Under current traffic regulations, the popularization of road monitoring has become very important. During the installation process of monitoring poles, the construction of the base and ground anchor plays a crucial role in the stability and effectiveness of the poles, therefore certain requirements need to be met.

​
​(The above is forChentianProduction status of 25 meter monitoring poles)

Monitoring poles are usually cast with concrete and reinforced cages：

• The size of the embedded parts for monitoring poles below 4 meters shall not be less than 0.3m0.3m0.6m，灌浇水泥尺寸不小于0.4m×0.4m×0.6m。
• 4至6米的监控杆预埋件尺寸不小于0.3m0.3m1.0m，灌浇水泥尺寸不小于0.5m×0.5m×1.2m。
• The size of the embedded parts for monitoring poles ranging from 6 to 10 meters shall not be less than 0.4m0.4m1.2m，灌浇水泥尺寸不小于0.6m×0.6m×1.5m。

​
​The above are for each section of the Daguang ExpresswayToll stations8 meter monitoring pole provided by the station)

In addition, it is necessary to reserve wiring pipelines with a diameter of no less than 40mm and a turning radius of no less than 200mm. The size setting of the monitoring pole base needs to be determined based on factors such as the length of the upright pole, in order to better ensure stability. If the length and base ratio do not match, problems may arise in the later stage.

Therefore, in the context ofMonitoring poleIn the establishment of the foundation, the construction and size setting of the base and ground anchor need to strictly follow the corresponding specifications to ensure the firmness and effectiveness of the upright pole.